Liferay 7.0 installation on Wildfly incorrectly references a 6.2 article

• Type: Task
• Status: Open
• Priority: Minor
• Resolution: Unresolved
• Fix Version/s: 7.0.x
• Component/s: None
• Labels: None
• Type of Documentation: Developer: Tutorials

At this section: https://help.liferay.com/hc/en-us/articles/360018175031-Installing-Liferay-DXP-on-Wildfly#running-liferay-dxp-on-wildfly-100-in-standalone-mode-vs-domain-mode

There is a note that reads as follows:

Note: This does not prevent Liferay DXP from running in a clustered environment on multiple Wildfly servers. You can set up a cluster of Liferay DXP instances running on Wildfly 10.0 servers running in standalone mode. Please refer to the chapter of this guide on Configuring Liferay DXP for High Availability for information on setting up a Liferay DXP cluster.

The link however goes to this 6.2 article https://help.liferay.com/hc/en-us/articles/360018183451-Introduction-to-Configuring-Liferay-for-High-Availability-.

Comparing the same 7.2 and 7.1 Wildfly articles, the note reads:

Note: This does not prevent Liferay DXP from running in a clustered environment on multiple Wildfly servers. You can set up a cluster of Liferay DXP instances running on Wildfly servers running in standalone mode. Please refer to the Liferay DXP clustering articles for more information.

And it links to its respective Liferay DXP Clustering article. Based on this, I believe the note on the 7.0 version should be linking to https://help.liferay.com/hc/en-us/articles/360018175191-Liferay-DXP-Clustering